My Qidi X-Plus 4 OrcaSlicer Profile (300+ Hours of Printing)

After putting 300 hours of print time on my Qidi X-Plus 4, I wanted to share the profile I’ve been using. I’ve tested it on two different machines and results have been very consistent so far, but as always, your mileage may vary depending on filament, environment, and tolerances.

This profile has been reliable for PLA+. It’s tuned for consistent adhesion, minimal stringing, and good overhang performance at reasonable speeds.

I’d love to hear what tweaks you’ve made, especially around higher-speed printing, retraction calibration, and specialty filaments. Drop your settings or results in the comments so we can refine these profiles together.

Ill have a full write up and review on the Qidi X-Plus 4 in the next few weeks. Stay tuned.

Download the profile here.